Entries Tagged 'planers' ↓

Link, credit cards now accepted by many Oak Park Farmers’ Market vendors

Many of the Oak Park Farmers’ Market vendors now are accepting Link cards that allow individuals receiving food assistance to purchase nutritious, locally grown fruits and vegetables. as an added benefit for all patrons, most vendors that accept Link cards also will accept credit cards.

“Poor nutrition is a major problem among our country’s lower income, a situation that is complicated by the lack of access to fresh fruits and vegetables,” said Oak Park Health Director Margaret Provost-Fyfe. “now, area residents who rely on food assistance programs will have access to nutritious items at one of the region’s best farmers’ markets right here in Oak Park.”

Provost-Fyfe called the acceptance of the Link card a major addition to the market, noting that the steps necessary to set up the program offered the added benefit of allowing patrons to use a credit card at most of the same vendor stalls that accept Link.

“beyond the obvious benefit to Link card holders is the convenience of a new payment option for other patrons as well,” she said. “Paying by credit card seems to be the trend for many shoppers, so it makes sense to be able to offer this option at our Farmers’ Market as well.”

Currently, 17 market vendors accept Link cards, which allow individuals participating in the federal Supplemental Nutrition Assistance Program (SNAP) to access their benefits with a card, rather than cash or food stamps. Oak Park is one of only 26 of the estimated 300-plus farmers’ markets in Illinois to offer the Link payment option.

Patrons who use a Link or credit card will choose their items and receive a receipt from the vendor that must be taken to the administration tent by the market’s main entrance where the actual transaction is completed. Purchasers then take the proof of payment back to the vendor and pick up their items.

The Oak Park Farmers’ Market is held from 7 a.m. – 1 p.m. every Saturday from mid-May through October in the Pilgrim Congregational Church parking lot, 460 Lake St., one block west of Ridgeland Avenue. more information on the market is posted at oak-park.us/farmersmarket.

Dust Collection Requirements & Recomendations?

I built a 16' x 16' shop in my backyard. I intend to use a table saw, radial arm saw, 6 1/2" jointer/planer, router table, 9" disk/6"belt combination sander, scroll saw, and a drill press(with mortising attatchment). I have never established a dust collection system before, and have no clue as to flow rate calculations, or pipe size.
I work in a sheet metal shop, can I use steel duct instead of pipe? yes, I can form Pittsburgh seams, and alum. tape will seal joints.
My tools will be located in an "L" shape along two walls, with the table saw in the middle of the shop, and the radial arm saw off center.
I know: Not much out feed in a 16' shop, but everything out feeds thru thoughtfully placed windows, and 6'0" double door .

Grizzly tools has good deals on dust collectors thing to remember if your the only worker in your shop than you only need enough suction to run one tool at a time. and like the other guy said you put shutoff gates at each tool and just open the one your using.

You can use steel duct to create the network of pipes to your collection unit. Refer to this website for an excellent article on creating a dust collection system and all the associated routing, pipe size, CFM info…etc.